CNET PRO200WL PCI Fast Ethernet Adapters
         SCO OpenServer 5.0 MDI driver Installation Guide
====================================================================    

Your Driver Diskette should contain the following files in the 
subdirectory \SCO-UNIX:

--------------------------------------------------------------------
Files           Contents                                                                                                 
--------------------------------------------------------------------
readme.txt      Text file about driver installation for the
                SCO OpenServer 5.0.

custom.dst     PCI Fast Ethernet Adapters MDI driver
                package for SCO OpenServer 5.0.
--------------------------------------------------------------------

A. Introduction.
----------------
    This is a SCO OpenServer 5.0 MDI driver for the PCI Fast
    Ethernet Adapter whose released version is 1.0.0b.

    The MDI driver requires the following hardware and software:

    - The PCI Fast Ethernet Adapters.

    - SCO OpenServer 5.0 or above.


B. Installation Procedure.
--------------------------

1. Prepare a formatted diskette on any DOS machine, and then copy the
   file 'custom.dst' to the subdirectory of the diskette.

   C>format a:

   A>mkdir sco

   C>copy custom.dst a:\sco

2. Now boot the SCO OpenServer 5.0 and enter the Maintenance mode.


3. The following sections describe the configuration of the driver. 
   It is suggested that you should perform these instructions in the 
   singler-user environment (maintenance mode).

   3.1. Run "scoadmin" command, and then select the "Software Manager"
        item to install DMFE MDI driver to SCO OpenServer. After
        the "CNET PRO200WL PCI Fast Ethernet Adapter" is shown, choose
        the "FULL" option to install this package.

   3.2. Select "Network" to add the desired LAN adapter in the Maintenance
        Mode. The steps for adding the new LAN adapter are listed below:

        a. When the "Network Configuration Manager" is shown, please
           select "Add new LAN adapter" option under "Hardware" main
           item. 
   
        b. When the screen "Add new LAN Adapter" is shown, then select
           the option "Configure hardware not listed above... ]". 

        c. After "Select network adapter to be added:" is shown, please  
           select  the  "CNET PRO200WL PCI Fast Ethernet Adapter"  item
           to add the driver into the system. 

        d. When the driver is added, the screen "Enter the configuration
           of the CNET PRO200WL PCI Fast Ethernet Adapter" will  be  shown,
           then please select "OK" item to finish this selection  if you
           do not make any change for the "Advanced options... ]". 
        
        e. When the driver is selected correctly, the "Add protocol" will
           be shown,  then select the item  "- SCO TCP/IP" as the default
           protocol stack. 

        f. After finished the "TCP/IP" protocol  sub-selection,  then the
           success message is shown as following: 

           "The following products were sucessfully configured into
                    the system:
            SCO TCP/IP
            CNET PRO200WL PCI Fast Ethernet Adapter"
                                             
        g. When the adapter has been configured, select 'q' from the
           menu, and relink the kernel at the prompt.

4. To active the adapter, you must reboot. 
        

5. If you encounter any problems during installation, (i.e., an error
   message appears on screen) call your dealer for assistance.



Brand and product names are trademarks of their respective companies.

==End Of File==