CNET PRO200WL PCI Fast Ethernet Adapter
               NetWare 5 Server for ODI Driver Installation Guide
               ==================================================


Installation Procedure
======================
Before you start with the installation process, make sure that the Novell
NetWare 5 server is properly installed. Similarly, your adapter should also be
properly installed in your workstation.

 1. Insert the driver diskette into drive 'A' and check the contents of
    sub-directory \NETWARE\SERVER.500, It should contain the following files:

    DM9PCI.LAN    *  Novell NetWare 5 Server Driver.
    DM9PCI.LDI    *  Novell NetWare Server Driver Installation Information
                      File.
    README.TXT

 2. At the NetWare prompt (indicated by the Server name), run the NWCONFIG.NLM
    program by typing:

     :LOAD NWCONFIG <Enter>

 3. The NWCONFIG program will prompt "Netware Configuration" windows on the
    screen.

 4. In the "Configuration Options" windows to select "Driver Options (Load/
    Unload/...)" and press <Enter>.

 5. Select "Driver options (load/unload/...)" and press <Enter>.

 6. Select "Configure network drivers", and then press <Enter>.

 7. Select "Select a  driver", and then press <Enter>.

 8. Press the <Ins> key to specify other drivers to install.

 9. Press <F3>, specify the driver path (A:\NETWARE\SERVER.500),
    and then press <Enter>.

10. The "DM9PCI.LAN | CNet PRO200WL PCI Fast Ethernet Adapter driver" should
    appear in your choice list for the "Select a driver" to install field and
    press <Enter>.

11. Choose this driver to start the driver loading and binding procedure. This 
    will allow you to load and bind all 4 frame types supported by NetWare
    server.

12. To complete the process, follow the instructions on the screen.


Installation Notes
==================

 A. You had better add the followings in the STARTUP.NCF:

      Set reserved buffers below 16 meg 200
      Set maximum physical receive packet size = 1530
      Set minimum packet receive buffers = 150

 B. You may specify the line speed and mode type you need in the AUTOEXEC.NCF 
    file. 

      :LOAD [C:]\<Pathname>\DM9PCI FRAME=ETHERNET_802.3 [Speed/Mode Type]

          If you do not specify the Speed/Mode type, the default is Auto-
          Negotiation(N-WAY).

   Speed/Duplex Types: 10HALF        ......      10Mbps Half Duplex
                       10FULL        ......      10Mbps Full Duplex
                       100HALF       ......     100Mbps Half Duplex
                       100FULL       ......     100Mbps Full Duplex
                       AUTODETECT    ......     Auto-Negotiation