filename: README.txt description: How to extend the NetWare* SNMP.NLM module to support the INTEL(R)-LAN-ADAPTERS MIB. Overview: ========= The LANAgent module extends the SNMP agent for NetWare*. It provides information on the Intel(R) PRO/100 and PRO/1000 Family of Adapters, through the adapter drivers (ce100b, ce1000), and additional information concerning the server features, such as teaming and vlan, through the Intel Advanced Networking Services (iANS) module. This file describes how to enable the NetWare SNMP module to support the INTEL-LAN-ADAPTERS MIB. Pre-Requisites: =============== The SNMP agent package will work best when the Intel PRO/100 and PRO/1000 adapter drivers (ce100b, ce1000), and/or the Intel ANS module (IANS) are installed and loaded on the system. However, the package will work with any combination of the 3 modules mentioned above. The SNMP agent package is compliant with the following driver versions: - CE100b.lan: ver 4.11 and above - CE1000.lan: ver 3.03 and above - iANS.lan : ver 4.14 and above Installation instructions: ========================== 1. Type "Load LANAgent" on the server prompt. 2. Configure the SNMP community name according to Novell* documentation. (e.g. type "Load SNMP ControlCommunity=" to enable GET and SET for any community name) 3. Register to receive Traps by adding the IP address of the management station to the list in the file SYS:\ETC\TRAPTARG.CFG. Available commands: =================== - "-h" or "help" - view the help description. - "cache_time=" - define a time period that the data structure is considered to be valid. Two consecutive queries within that time will not cause update of the data. This value is set in tenths of a second. Default value: 50 (5 seconds). - "trap_time=" - define the time period between two consecutive trap checks. The units are the same as for cache_time. Default value: 10 (1 second). - "status" - view the current values of these variables. * Other names and brands may be claimed as the property of others.